Ocean Rodeo ROAM Gen3
FREERIDE FOIL BOARD / SURF
Using a carefully selected mix of Dacron and ripstop, we have created a super light yet rugged 3-strut air frame.
Although the Roam’s design remains familiar in Gen 3, the kite’s flying weight has been greatly reduced (weighing-in lighter than most single strut kites), improving its performance not just in light wind, but in all wind conditions.
The ultra light weight and deep foil profile in combination with a moderate arc provide for sharp, responsive turns, maximum drift, and the low-end hover sought out when freeride foiling, or drifting down-the-line on your surfboard.
With the Ocean Rodeo Roam Gen 3, there is no longer a need to compromise on stability and wind range in favour of no struts.
Built for the dedicated wave rider with a moderate arc makes the roam a fast turning kite combined with a large sheeting range.
The Roam’s low aspect ratio design and deep foil profile allow for maximum drift and low end power.
The Roam’s 3 strut “boxy” frame results in its big lifting wingtips allowing the kite to effortlessly drift down the line while maintaining positive steering with tight pivot turns for ultra fast changes of direction.
The entire frame is built with tested and proven KP-E dacron providing incredible strength, durability, and rigidity. Where our competition choose to reinforce their closing seams with only mark cloth, we use more KP-E because we believe reinforcement materials should be at least as strong as its base.
A fixed short line bridle with a floating V design and a two pulley system creates direct and snappy response while also keeping bar pressure low. New to this generation are larks head loops on front bridles, and knots on the back lines making for an innovative system that stabilizes the leading edge. This allows the Roam to lift out of a loop and avoiding a stall for maximum climb.
A single front line flag out systemin is used allowing the rider to achieve maximum de-power if the trim loop release is activated..
WARNING! It is crucial that the bar you are using utilizes this system.
Note: For Next Gen kites we have changed the bridles on our kites so that the front attachments have loops and the back attachments have knots.
In order to use a previous generation Ocean Rodeo bar with a Next Gen kite, you must first install the OR Bar Bridle Adapter Kit (which can be purchased from a dealer or directly from Ocean Rodeo) to the bridles on the kite. This will change the bridles so that the front attachments have knots and the back attachments have loops. Thus making it compatible with the older model bars. Click here for more information.
DIMENSION POLYANT K-PE DACRON
Dimension Polyant’s K-PE dacron utilizes PEN (polyethylene naphthalate) fibers in the warp direction. PEN has a higher modulus than polyester and these fabrics exhibit approximately 30 to 40% lower stretch than their polyester equivalents. This makes K-PE the ideal choice for kite dacron where low stretch is a top priority.
K-PE fabrics are produced utilizing DP’s patented X-PLY® technique assuring reliable performance and the highest quality lamination available on the market.
TEIJIN TECHNO FORCE D2 RIPSTOP
Designed specifically for the kiteboarding market, Teijin’s Technoforce D2 Ripstop has high tear resistance, low stretch, and is incredibly light weight.
Each Strand of yarn is individually coated before being woven together. A second surface coating is then applied to the material, providing long term endurance.
Teijin D2 is the benchmark in quality with proven superiority in durability and dynamics.
Sizes 5, 6, 7, 8, 9, 10, 12